So I my previous post I mentioned an idea I had for a total gyro controlled plane no control surfaces just a gyro and this is what I found after my initial 20minutes of testing

how I achieved this

So what I did was a made the airframe and added a gyro and two hinge rotators, one for pitch and one for roll. The only reason for the wings is for stability. Each rotator is set at 45°s and is inverted. the gyro is 250% on everything.

so the initial testing

So when I first spawned it in the hinge rotators were not invented so the controls were invented but it was seeming to work fairly well the only problem was thrust ( the smallest jet engine on 6 times power which was upgraded to the next one up at the same power level). After inverting the rotators and changing engines the problems started showing themselves.

the problems

When pitching up it is really hard and it can stall the plane with the loss of airspeed and after a few seconds its pitch authority is SO bad it would probably take about 1 minute or more to do a full roll. Speaking of roll the roll seems to be the way to gain back airspeed lost to pitch but you can only roll so far and it really isn't much, not much better than the pitch after the few seconds of actually pitching. More testing will be done where I will mess with gyro strength, the amount of degrees the hinges have.

this is an ongoing project so more posts will be made and a final review will be made before I release the plane I used for the experiment