I’m making a plane
YES IM ACTUALLY MAKING SOMETHING :DDDD
Anyways, when I takeoff from any airport, my plane veers to the left so hard. My CoM, CoL, and CoT are all in the middle, and it just veers. Any suggestions?
I’m making a plane
YES IM ACTUALLY MAKING SOMETHING :DDDD
Anyways, when I takeoff from any airport, my plane veers to the left so hard. My CoM, CoL, and CoT are all in the middle, and it just veers. Any suggestions?
@KingOog000 No problem!
@Macrophage thanks!
@KingOog000
1. Drag. Left side greater than the other.
2. Visual mistake. Any visual mistake? This mistake can be removed or fixed.
3. Vertical stabilizer fin. It may or maybe pointing in some direction causing this movement. Check the X axis (Maybe axis)
4. Landing Gear misalignment. It May or Maybe misaligned. Check the gear.
5. Control surfaces. Some may be activating the yaw when you do pull....
6. Engine. When you have 2 engines, then add some activation groups, you may have forgotten that these engines have activation groups. Or, the activation group of the right engine is far different from plan.
7. Engines. Did you XML Mod them? If you do, check if both engines are equal.
8. Size. The landing gear on the left may have a smaller size.
.
-That's all I know.
@Musraskrois ah ok
Can i test it?
The drag might not be the same in both sides of the plane. This could cours this problem. If this is the case make it so you can see the dragpoints on each block. You do this the same place where u save and load planes. Then see if you can see some parts that have more drag on one side than the other. Them remove the drag from these parts. Again idk if this is the problem but it could be. Hope this was helpfull and good luck with the plane.