I have been working on a plane and I would like to do fuselage wings. I have decided to not do fuselage control surfaces for now and stick to the standard ones on the wing parts themselves.
My problem is that I can't find a way to finely adjust the control surface shape as I did with the wing shape (using overload). The only way I could figure out was by dragging the blue arrows, which is not very precise. Is there any other way to adjust the shape of the control surface?
Thanks.
Question about control surfaces
915 ElevatorEnthusiast747
3.0 years ago
Nope, I've tried it before, and if you wanted to do it, you'll have to use 2 wings.
you could try xml scaling the wing down (make sure to adjust the weight and drag too) and then adjusting it normally in the designer, however thelift produced will be far greater resulting in unnatural pitch and roll, alternatively you could use structural panels as well to resemble wings that don't have the consequences of the unnatural pitch and roll.
Hope this helps
unfortunately i dont think so