This is short.. im making an Me-163 and with that design the pitch and roll controls are on the same control surface. I have the rotor(custom control surface) mapped with ‘roll + pitch’ and ‘roll + -pitch’ on each side respectively. When using roll or pitch fully, it works fine, but when i pitch and roll at the same time, roll gets inverted, or just dosent work smoothly, is there any easy fix?
has de nuevo el punto de balance de tu avión ;seguro has añadido cosas de más y no tiene suficiente balance
Do you mean like- the surface inverts or the roll rate?
I have no experience over custom elevons whatsoever.