Oookay, I didn’t think I was going to make a forum again for a while but apparently something has come up on my build that I can’t find a way around.
I put engines on my craft and it’s telling me my vtol engine is not getting enough air. In a blind fit of rage after trying every solution while trying not to make it look ugly, I stick as many inlets as I can onto my aircraft and it still says you.
FYI: Your engines aren't getting enough air.
Try putting some inlets on your plane.
Is there a way to just deactivate that thing? Because I made a really good chopper and the engines were a pain to create.
My solution is engine power in XML set it to the ridiculous number and just get rid of afterburner as well in XML
Too ugly you mean? Just resize them into the size of an bacteria! Always works!
Try adding a inlet fuselage part (its in the propulsion category) and put it on the very front of the aircraft then hide it inside just by moving it back into the nose and it should fix it, if it happens again where it says you need more air just replace it to where it was before
Putting too much engine can cause this, but I never had this issue.
happened to me a few days ago. what I did is I just tried to directly expose the engine to the front of the craft as much as possible. Eventually worked... a bit.. I think