Is it possible to invert an action group input? I'd like to have it so a hinge rotator doesn't move when Action group 7 is pressed, but moves like normal when off.
Is it possible to invert an action group input? I'd like to have it so a hinge rotator doesn't move when Action group 7 is pressed, but moves like normal when off.
@Lancer270 Try !Activate7 in the magnet activation group (put it there using Overload).
@PlaneFlightX What would I need to invert the action group on a magnet? I need it on at all times except for when 7 is enabled.
You can add
smooth(FunkyCode, clamp01(Activate7))to your rotator in the input section. This will have the same behavior.@SILVERPANZER Does that work for the activation group input or the input slot? The input slot is already taken up by funky trees on the rotator. I want to make sure the funky trees is off when 7 is pressed.