After Nearly 2 years of a troubled 3D printing, cancellation and waiting on friends - I FINALLY finished my re-attempt of 3D Printing my A-8F Aquan II
To compare, Here is the model next to My older 3D print of the Aquan & My 3D print of the AV-8B Harrier
This time I used acryllic paint instead of the water-based stuff. It can get thicker, leaving a bit of a clunky patchy areas. I took the below F-105 Wild Weasels "Southeast asia Camo" paint job as inspiration for the paint:
Here is the original 3D model in case anyone wishes to 3D Print it.
And before anyone asks, no. I will NOT be printing your models. But If you want help or tips, I'd be more than happy to help were I can.
@Falkenwut thank you
@MIGFOXHOUND31BSM26 thanks, I'll get to it when I get the chance later today.
@Falkenwut here you go version without interior
@Falkenwut 1. Thank you
2. no, that gets taken out
@MIGFOXHOUND31BSM26 I will do it as soon as I can.
Are you intending to 3d print the interior? I personally don't do it, and I don't have the resources to do it.
Would you be able to help me get this into a 3d print please, whenever I slice it, it doesn’t slice properly