Use the small cockpit and make it to the main one and remove the one you have if it is scaled as i have heard that they can make the drag different. Then just nudge in the small one and no one will see it.
@Ian1231100 did you try trimming the rudder? Point leading edge of the vertical stabilizer a few degrees towards the side that goes down and see if that helps.
@Ian1231100 ok :)
@Minecraftpoweer I'll give it a shot.
@Minecraftpoweer I'll give it a shot.
Use the small cockpit and make it to the main one and remove the one you have if it is scaled as i have heard that they can make the drag different. Then just nudge in the small one and no one will see it.
@Ian1231100 can't wait to see :)
@EternalDarkness Well then, I'll try my best.
@Ian1231100 why not a great entry? You can do it buddy. There's 10 days to go.
@EternalDarkness Thanks for the advice. I've rotated the stabilizer by 2 degrees and it flies normally now. Expect a (half-)decent entry. :)
@Ian1231100 did you try trimming the rudder? Point leading edge of the vertical stabilizer a few degrees towards the side that goes down and see if that helps.
That happens a lot with custom wheels (why I try and avoid making them). Best bet is rebuild the wheels/landing gear from scratch. @Ian1231100
@Jengstrom Vertical stabilizer was set to symmetric airfoil, and it still auto-yaws. And I just couldn't explain the asymmetrical drag.
Check for uneven drag, and make sure your vertical stabilizer is set to a symmetric airfoil