my friend has told me dat on very small planes da center of mass should be in the middle but a bit back from da middle? But dat is on propeller planes.
1.COL behind COM
2.Rear landing gear behind COM
3.Control surfaces large enough to control plane
4.Make sure you have enough gear to support the weight
5 Ensure that the engines are powerful enough
6.Ensure that the wings are large enough
Check out my new jet that I made!https://www.simpleplanes.com/a/eDyZ0Q/The-Black-Hawk
Thanks everybody for all the tips!
my friend has told me dat on very small planes da center of mass should be in the middle but a bit back from da middle? But dat is on propeller planes.
1.COL behind COM
2.Rear landing gear behind COM
3.Control surfaces large enough to control plane
4.Make sure you have enough gear to support the weight
5 Ensure that the engines are powerful enough
6.Ensure that the wings are large enough
Have com in front of your col
Use structural wings where you need a wing but not a control surface. This helps to prevent floppy wings