soft body physics(realistic crash) hispano ha-300 (under fuselage intake config)(fixed front landing gear falling off after retract issue)
note : i deleted the original earlier post because i had to fix landing gear coming off in the air issue, this is my first fully functional soft body plane , warning wings can break if you pull too much g , may be hard to fly requires precision , it features ejectable seat in case , its activation group 2 for the ejectable seat and 3 to deploy parachute , also for takeoff i recommand around 80 percent thrust and 21 percent to land for a perfect landing also takeoff and landing can require some training as if you land too hard the plane will break, tell me in the comments if you encounter issues or problems with the aircraft also ign the factore that it benches to the rear when its stopped and also that it swerves to the sides on takeoff and landing its just some issues that i still havent managed to fix but as this is my first real try at this type of physics i will try to get better for the future models, hope you enjoy the physics :D
Specifications
General Characteristics
- Created On Windows
- Wingspan 16.7ft (5.1m)
- Length 24.5ft (7.5m)
- Height 10.6ft (3.2m)
- Empty Weight 596lbs (270kg)
- Loaded Weight 729lbs (330kg)
Performance
- Power/Weight Ratio 36.967
- Wing Loading N/A
- Wing Area 0.0ft2 (0.0m2)
- Drag Points 249
Parts
- Number of Parts 3
- Control Surfaces 0
- Performance Cost 1,183
@JetFlyJosef Thanks a lot :D , well yea it even took me a lot of time just to figure how to land properly with it XD
@JetFlyJosef hi, well yea i was surprised the part counter doesnt counts the parts that are not attached to the flight computer but its because for this type of physics to work properly , the main cocpit( in this case i used a flight computer) c ant be attached to the plane or else the prescripted crash physics in the flight computer completly ruins it by making the whole thing explode directly , but as i c ant power the engines without the flight computer but i c ant make a direct connexion with the plane i had to only attach it to the engine and make it hold to the aircraft artificially , if you look at the rear of the aircraft you will see a box of modified fuel pannels (i used fuel pannels because it has good collision hitbox) well this box was made just to hold the flight computer and as the flight computer was too small and falls off the box due to bad hitbox i had to attach the flight computer to a cube (i also used another fuel tank for that to power the engine and hold it at the same time) and the cube connected to the flight computer wich is connected to the engine is being held in this box so in recap the flight computer is only connected to a fuel tank and the engine so thats why it says 3 parts only
Btw why does it say 3 parts
The crash physics are pretty good. It’s just to hard to fly