Profile image

HEEEEEEELP

6,221 Apehorse19  8.1 years ago

I don't know what I'm doing

Spotlights

General Characteristics

  • Created On iOS
  • Wingspan 12.5ft (3.8m)
  • Length 17.1ft (5.2m)
  • Height 6.2ft (1.9m)
  • Empty Weight 1,193lbs (541kg)
  • Loaded Weight 1,698lbs (770kg)

Performance

  • Horse Power/Weight Ratio 0.588
  • Wing Loading 62.3lbs/ft2 (304.3kg/m2)
  • Wing Area 27.2ft2 (2.5m2)
  • Drag Points 608

Parts

  • Number of Parts 18
  • Control Surfaces 1
  • Performance Cost 103
  • Log in to leave a comment
  • Profile image
    9,650 jfriss

    @Apehorse19 final entry boeing 747-400 it is KLM livery

    8.1 years ago
  • Profile image

    key il upload the fixed versiol if it needs it in a sec (goes into sp and starts building)

    8.1 years ago
  • Profile image
    6,221 Apehorse19

    Oh, what is it called?@jfriss

    8.1 years ago
  • Profile image
    9,650 jfriss

    @Apehorse19 i was just saying i have a WAY better one

    8.1 years ago
  • Profile image
    6,221 Apehorse19

    Thank you very much, I have created a new "prototype that has been uploaded regarding everyone's comments. Thank you.@IStoleYourMeme

    8.1 years ago
  • Profile image
    6,221 Apehorse19

    Thank you, I have@Chimichungas

    8.1 years ago
  • Profile image
    6,221 Apehorse19

    Exquese me? That is better than my planes so I did, also it looked really cool. And in flight it was not bad for an airliner.@jfriss

    8.1 years ago
  • Profile image
    9,650 jfriss

    why did u upvote that 747? it sux!

    8.1 years ago
  • Profile image

    • lower pitch angle to 15 or 10 degrees so you don't blow up pitching back
    • lower engine power to about half so it doesn't flip uncontrollably (it will still pitch up a little but it will still fly much better)
    • optionally, increase roll angle a bit so increase high speed maneuverability
    voilà you have a decently flying heli
    source: i tested all changes above

    8.1 years ago
  • Profile image
    6,221 Apehorse19

    The lines are aligned however the big corcles aren't. Thank you though@Engineer

    8.1 years ago
  • Profile image
    6,221 Apehorse19

    Thank you @jfriss

    8.1 years ago
  • Profile image

    Make sure the center of mass is on the propeller, or helicopter blades. If not, then try adding weight to the front or back until the COM is on the blades.

    8.1 years ago