High Colossus Steam Train
READ FULL DESCRIPTION!
This is the final version of the High Colossus, my largest and most advanced steam train. Do not let its weight of 1.23 million pounds fool you — it can accelerate past 100 MPH on Yeager Airport. The bell is, sadly, merely for show. There is a firebox which lights up when the train's speed is increased. The smokestack is automatic and powered by two cleavers. There are two cameras in the cab, a camera on the rear car, and an orbit camera inside the locomotive. If you want to remove most of the weight, take all the fuel out of the engine and the coal tender.
The controls are:
AG1 - Trim for reverser, VTOL for thrust
AG2 - throttle up to 100% for locomotive brake.
AG3 - throttle up to 100% for train brake.
Do not use the train brake while the High Colossus is in motion as it may cause the brakes to explode, which may result in the cleavers detonating if the explosion reaches the smokestack.
Have fun! ALL ABOARD!!!
Specifications
Spotlights
- Kalanimcd 5.9 years ago
General Characteristics
- Successors 1 airplane(s)
- Created On iOS
- Wingspan 19.7ft (6.0m)
- Length 558.2ft (170.1m)
- Height 25.6ft (7.8m)
- Empty Weight 184,568lbs (83,718kg)
- Loaded Weight 1,231,650lbs (558,668kg)
Performance
- Power/Weight Ratio 0.075
- Wing Loading 439,839.3lbs/ft2 (2,147,483.6kg/m2)
- Wing Area 0.0ft2 (0.0m2)
- Drag Points 133970
Parts
- Number of Parts 612
- Control Surfaces 0
- Performance Cost 3,094
Also I only have the engine and tender and it already weighs a million pounds :) @Kalanimcd
I'll make the train on IOS then publish it temporarily, then I can download it on PC, add the smoke trails, then delete the original and publish the new one. Sound good? @Kalanimcd
@RasucitNemilos also for steam trains get the smoke trails mod
@RasucitNemilos use the wheels on mine and have 2 car engines one set to forward on the front or back boogey and the other set to reverse and have them group activated and use the couple's I used
Welp, I’m building another train. Any tips of massive wheels and drive arms? @Kalanimcd
@Kalanimcd I am officially on the PC version of SimplePlanes :D
Did you use car engines on the post I commented on?@Kalanimcd
@RasucitNemilos you're on iOS? Ok than use one if my diesel trains
I found one of the trains but unfortunately I can’t get it because it uses a mod I don’t have. I always used a cleaver for smokestacks so I didn’t need to use a mod. When I get SP on the pc I will try it out @Kalanimcd
I don’t and unfortunately I’m on iOS so that may be a bit of a problem. I may get it on PC eventually but for now I'll just use Yeager Airport. I might upgrade the engines to J90s just for the speed but for now I’m satisfied. Thanks for the recommendation though! @Kalanimcd
@RasucitNemilos look on my profile in my posts you will see some trains try them out with the so railway mods
@RasucitNemilos I recommend you use a railway map mod if you don't already
Thanks! It took a while to make, especially starting out the body of the locomotive. Also, I’m not sure if you noticed, but when the train gets moving, the drive wheels aren’t moving at all. Also I was going to make each car have 8 wheels but I was trying to keep the part count down. I might make another train eventually, but I’m gonna keep it at this one for now :) @Kalanimcd
Nice one man