Pk-3
Tier II Medium tank
(Wright armour)
Standard build, this build uses a low number of parts for low end devices to be able to spawn more than one, standard part limit is capped at 115, anything beyond 115 is considered a fully detailed collectible, and is no longer a standard build.
A fully detailed variant of an already existing standard build might be made, keep an eye out.
Controls
-Yaw For Hull Traverse
-Enable Foward And Reverse (AG1)
-Pitch For Foward And Reverse
-Enable Gun Traverse (AG2)
-Pitch And Roll For Gun Traverse
(Tip: Hold pitch up and disable AG1, this locks the throttle in place, allowing you to aim & fire on the move!)
Description
A medium tank with a 75mm in the 30s, of course it was decent, with good operational range, weight and maneuverability, despite having severely outdated protection and arnament, it was still used throughout the war, albeit in small numbers.
Before the war even started most of these tanks were already exported and replaced, only few actually saw action, obviously they were a rare sight during the start of WWII and even more so during the end of WWII additionally many were knocked out aswell, since they're easily dealt upon by anti-tank guns.
Service: 1930-1945
Production: 1930-1934
Is mass-produced: no
Armor (RHA-Equivalent in mm)
-(19)Hull front
-(13)Hull sides
-(13)Hull rear
-(20)Turret front
-(20)Turret side & rear
-(50)Mantlet
Arnament
M011 75mm
-(77) Of penetration at 50m (AP)
-(5.6) average reload time
-(0) explosive mass
Mobility
(37) kph, average speed
>
Low part count, always lower than 240, mostly less than 100 with all parts set to calculateDrag = false, enables you to spawn more than one without any issues.
>
Realistic performance, all vehicles perform as realistic as possible in mobility and firepower.
>
Advanced damage model is present, simulation of damage depending on armor thickness & angle, only works when against basic rounds, works best against other vehicles of mine.
>
All my recent vehicles can effectively engage each other the way it is supposed to, very useful for MP roleplay encounters or battles.
Creator's note: Another tank based on one of my old drawings, hehe.
Thank you!
Specifications
Spotlights
- Rondine 3.7 years ago
General Characteristics
- Created On Android
- Wingspan 5.7ft (1.8m)
- Length 11.8ft (3.6m)
- Height 5.8ft (1.8m)
- Empty Weight 609lbs (276kg)
- Loaded Weight 3,371lbs (1,529kg)
Performance
- Wing Loading 439,839.3lbs/ft2 (2,147,483.6kg/m2)
- Wing Area 0.0ft2 (0.0m2)
- Drag Points 0
Parts
- Number of Parts 51
- Control Surfaces 0
- Performance Cost 424
Link to realistic damage model demonstration