My entry into the Anti Air challenge!!

This is a revamped and modified version of a chassis I did a few weeks ago, it's been made stronger and lot more stable. The centre of gravity is now basically inline with the axles so it handles hard corners alot better, and it takes alot to get it to roll over.

The weapons system is brand new and done from scratch, its not based on anything, I've just gone at it and made it. It carries 8x interceptor long range missles and 8x guardian short range missles. As well as a mini gun housed below the aiming and radar system mounted to the side of the carrier. So it covers most of the air defense requirements.
The system also houses anti radar lock devices in the form of flare launchers mounted to the other side of the carrier which lock into a 45° position for best dispersion.

The instructions are pretty simple as it only relies on 4 activation groups and VTOL & Trim control. However ensure you use the correct sequence or it will go wrong!!!!!

AG1+VTOL DOWN will move the lifting Jack's and support legs into position as well as deploying the countermeasures and radar sensor.

With VTOL STILL DOWN activate AG2 and that will extend the lifting jacks, lifting the vehicle off the ground.
Once this has been achieved deactivate AG1 & AG2 and return the VTOL to a central position.

AG3 will activate the weapons system and allow it to be moved to the desired position.

ONLY SLIDE VTOL UP WHEN CONTROLLING THE WEAPONS SYSTEM. THIS ALLOWS IT TO RAISE UP TO AN ANGLE OF 55° LOWERING IT FORCES THE CARRIER INTO THE CHASSIS CAUSING IT TO FAIL.

The rotation is controlled via the trim slider and it has a rotation of 180° both left and right...

TO STOW THE WEAPONS SYSTEM BACK, SLIDE BOTH TRIM AND VTOL TO THEIR CENTRAL POSITIONS AND DEACTIVATE AG3.

With VTOL back in its central position and AG3 deactivated, to can activate AG2 to lower the vehicle and close the weapons system door. Then activate AG1 and the support legs will rotate back into their stowed position.