Only 2 attachment points to connect this to your next project. Comes w lights. Just connect the end of the spring & the round piece of fuselage around the rotator to your aircraft. It's that simple. It will retract through an existing fuselage or you can create your own doors. I don't remember where I got this but I will add credit if I do. Enjoy.....Z
Specifications
General Characteristics
- Created On Android
- Wingspan 9.5ft (2.9m)
- Length 14.3ft (4.4m)
- Height 6.9ft (2.1m)
- Empty Weight 595lbs (270kg)
- Loaded Weight 595lbs (270kg)
Performance
- Wing Loading N/A
- Wing Area 0.0ft2 (0.0m2)
- Drag Points 385
Parts
- Number of Parts 3
- Control Surfaces 0
- Performance Cost 299
@Zaineman got it, thanks.
@Stanmich don't allow the fuselage to touch (make a connection by itself) to any part of the landing gear other than the two places I indicated or the landing gear will not function. Sometimes I have to go into manual connections and make sure nothing is touching the landing gear shaft or any other parts
The landing gear is attached and working (some where about 20 feet from the plane) in the space. :( lol
I think the error was because it was touching the fuselage, I will try again. I got busy during the day, thank you so much though @Zaineman
@Nowhere thank you for the upvote
@winswings did our discussion help ? Again,use the main picture as your guide and use manual attachment to do your 2 attachments. First, drag the whole thing into you sub assemblies. Next,drag out of subassemblies but don't let it touch your aircraft. (If you do it could attach itself in the wrong place) First, open attachments then move your curser over the end of the spring at the far end of the unit. Add attachment to your aircraft. Second, (as indicated in my picture) put your curser over the little round peice of fuselage with the smaller round object in the center (the rotator) In the picture this is the YELLOW part. Before you make any connections, you should ONLY see under connections is "small rotator" . Connect the OUTER round part to Any part of you aircraft and you are done. ( 2 connections, spring and round piece of fuselage with rotator in the center) that's it.
I am still struggling with connections. I don’t know how it connect