click here for video tutorial

whats new?
-just simple changes so it work with airplanes that have funky trees control
-pitch and roll angle modifier

JUST ADD YOUR OWN AIRCRAFT HERE

or build from here

HOW TO USE

• 1 save your airplane in Sub-assembly (disconnect cockpit so you can make sure all of the aircraft can be moved and save)
• 2 make sure your aircraft didnt have custom variables, if have you have to move it too
• 3 add your aircraft to this autopilot buttons
  in custom variables,theres roll,throttle,pitch and yaw
• 4 change inputController on each control xml, so change
  any Roll input to roll (all lowercase/remove capital), also the Pitch and Yaw to lowercase pitch and yaw on their respective control surface/wing

and done!
ps, if one side of elevator/wing turning upside down, set it to invert mode

you can remove the fuselage,and the blue button that act as display. i just pressed the button to make the number visible
and It can also work as the activator, you can remove one of the button, the display one, or the AP one (A/T , ALT , HDG)

how to use the autopilot

• just click A/T (or the speed display) to activate Auto Throttle, press the + / - button to add or reduce speed by 1, press 1/5 button to change by 5
• click ALT button to activate altitude hold, currently theres about~30ft offset depending on the speed also click 1/100 to change the Altitude by 1 or 100
• click HDG to set the heading, can also be changed to add or subtract by 1/5

also you can resize,rearrange the buttons
or change buttons, just set input the same to the one you replace.

the speed is in Knots,IAS
Altitude is in Ft,Asl

work on most planes

this is wasp with the autopilot

dont forget upvote 👌
credit if you willing to, but not required