Profile image

Prototype flying ball ( 2000mph)

510 Boggartbob  9.9 years ago
129 downloads
No Tags
Auto Credit Based on Boggartbob's Prototype flying ball ( 2000 mph) generation 2.

this prototype flying ball is a vertical lift craft sorry no paint job yet :p but this generation 2 craft is more stable and a a good bit faster..... will develope itz steering next ..first hit detacher 1 then throttle to NO MORE THAN 15 PERCENT and then quickly push vtol into top slider position.... if your controls are inverted then your technically upside down. then climb to 15k feet and punch the throttle...do not exceed 44 percent throttle while under 12k.. Please enjoy my prototype rate and comment.. if popula ar I will develop

General Characteristics

Performance

  • Power/Weight Ratio 3.802
  • Wing Loading 1,282.3lbs/ft2 (6,260.8kg/m2)
  • Wing Area 149.3ft2 (13.9m2)
  • Drag Points 38919

Parts

  • Number of Parts 395
  • Control Surfaces 10
  • Performance Cost 1,264
  • Log in to leave a comment
  • Profile image
    18.6k Teus
    Oh okay, I'll check it out
    9.9 years ago
  • Profile image
    @Teus... look in my planes list I have generation 3 out buts it's a complete rebuild so not linked to these old flying balls..... it's bigger and painted
    9.9 years ago
  • Profile image
    18.6k Teus
    I like it! A bit hard to control but as I you said, you're already working on it. Maby you could add a nice paintjob to your next version too. A nice paintjob is always good to have.
    9.9 years ago
  • Profile image
    OK so... best not punch it until above 20k feet. ... also sometimes the ball falls off the stand... just restart it's rare. Control is poop.. so I'm a work on that.
    9.9 years ago