No Tags
just asking if there's another way to precisely Find The center of mass of an aircraft?, like is there a mod for it? (when i say "precisely", I meant PRECISELY)
Specifications
General Characteristics
- Created On Windows
- Wingspan 24.6ft (7.5m)
- Length 4.9ft (1.5m)
- Height 8.2ft (2.5m)
- Empty Weight 1,455lbs (659kg)
- Loaded Weight 1,455lbs (659kg)
Performance
- Wing Loading N/A
- Wing Area 0.0ft2 (0.0m2)
- Drag Points 10540
Parts
- Number of Parts 42
- Control Surfaces 0
- Performance Cost 74
@Philip1214 if you did the "ground school" level,you would also have noticed that the CoM should ALWAY be in front of the CoL
@Philip1214 maybe your CoT make it tilt?it's also possible your CoM is too close to your CoL.Or maybe your engine is too strong and you should try smaller ones.
If you checked all of this,you can also send me a unlisted plane so i can try and see what's wrong.
@Artutu Thank you ! but I'm all right with every symmetry and balance, i just want the center of lift and center of mass perfectly matched in the same X,Y,Z location
@ThatDr42 thanks a lot dude, well my plane is using a really strong engine, and just the smallest misalignment will make the aircraft slowly tilt up or down (depends on how it's misaligned)
Well, even though I’m making ground transport, I think it’s worth doing this: parts that are symmetrical should be left with weight, and those that are not symmetrical should naturally be turned off,
And also to make forum you go to "forum", and then you click on "new post"
I dont think so,the red lines are going to be your most precise way to find it. What's wrong with your plane?
ik this looks stupid but please bare with me