Just a little side project, and an excuse to mess around with the new 1.11 stuff for a litte while. The Radscout goes at about 100 mph and can go up near verticle inclines. Instructions can be found in the craft instructions menu, which is right above the 3D print/export button. Have fun
Specifications
Spotlights
- CookingWithCinderBlocks 3.2 years ago
General Characteristics
- Created On Windows
- Wingspan 9.0ft (2.8m)
- Length 19.8ft (6.0m)
- Height 8.7ft (2.7m)
- Empty Weight 7,165lbs (3,250kg)
- Loaded Weight 8,723lbs (3,956kg)
Performance
- Wing Loading N/A
- Wing Area 0.0ft2 (0.0m2)
- Drag Points 3991
Parts
- Number of Parts 138
- Control Surfaces 0
- Performance Cost 836
@FishMiner, yes but motorcycles’ wheel dihedral is not as extreme as this rover.
@Bellcat its the same way the front wheel on a motorcycle works so...
@FishMiner, well if that’s so, that would have been inefficient.
@Bellcat It has normal steering, its just that the point of rotation is at an angle so its harder to see. Just look at the craft from a top down view and you will clearly see how it works.
You did not put this into the VR challenge?
.
Unique suspension. There isn’t any way for the wheels to turn. Is this a skid steer rover?
@GalaxyMustache the last time someone asked me to make something it resulted in a downright awful build, so don't hold your breath.
Finally I've been waiting for you to make cars? again, please continue to make them