Must be mounted under aircraft as shown. Be sure to keep the blue rotator under the yellow rectangle. That is, first the rectangle, then the rotator mounts underneath as shown. Then the entire assembly mounts under the aircraft. It's activated on 2.
Specifications
General Characteristics
- Created On Android
- Wingspan 0.8ft (0.3m)
- Length 6.1ft (1.9m)
- Height 1.1ft (0.3m)
- Empty Weight 69lbs (31kg)
- Loaded Weight 69lbs (31kg)
Performance
- Wing Loading N/A
- Wing Area 0.0ft2 (0.0m2)
- Drag Points 63
Parts
- Number of Parts 9
- Control Surfaces 0
- Performance Cost 70
This thing is giving me fits trying to install it on a tank or another aircraft. So I made another version of it with a much longer connecting beam and posted it. The idea is not to disturb the connections between the red beam and the black, gray, orange components of the gun. Once it's mounted and you verify that it's working, save your project, then go back and shorten the red beam. You can even launch it onto an airfield as it sits right now (the new post), press 2 and watch it jump around tracking targets. Lol
I checked it real quick. It works. First remove flight computer then drag into sub assemblies. Once your aircraft is pulled up, pull it out of sub assemblies. Next, be sure to grab it by the Yellow block. Next, drag it to beneath your plane. Press 2 to activate it, then select Canon under air to air or air to ground. If you have any problems comment and I will do my best to help you. Z
@Captiandaves lol no that's just luck I guess. Heck I didn't even notice. Too funny
Did you purposely make it 69 pounds?
@Captiandaves It is not an easy thing to deal with. You want to drag it into your sub assemblies in the upper left hand corner then name it. When you bring it out, grab it by the top of the structure, that is , the cannon would be below. Then drag it underneath the aircraft. Another thing I've been doing is taking the round fuselage shrinking it down pressing the button hard edges to create a small square. Next I bring it close to the rotator assembly that's on top (if you take the block on top off of the rotor assembly, you would do this by pressing attachment button and pressing the x next to the fuselage attachment) this allows that piece of fuselage to be dragged away from the rotator part of the cannon.) Now get it close to above the rotator but don't attach it. Use the manual attachment buttons to create your attachment from the top of the rotator to the bottom of the shape you made. Once you create your attachment, use the nudge buttons x y and z to bring your horizontal block down to the top of the rotator. Once this is complete drag the top box you just connected to the bottom of your plane. The entire assembly should come with you. It's not easy even for me, but if you make a mistake you have the original assembly inside of your sub assemblies to try again. The main thing is to be sure you don't accidentally take the entire assembly apart, and be sure it's mounted beneath your aircraft. If you did it successfully, once it's activated it should be pointing all over the place tracking a Target. I hope this helps. If you have a more specific problem, just contact me and I will help you. I'm sort of new to all this as well.
It’s not going well I suck at building
Ok
@Captiandaves let me know how it goes. Once mounted below & activated, you should see it moving all over the place.
I shall make artillery or attempt lol