Here is a reloadable spring gun that shoots balls up a ramp and onto a track that brings the ball back into the queue. You should be able to get this to work for 95%+ of balls with just a little practice (there are a fair amount of controls to learn but doesn’t take long).Controls: AG1: activates piston for spring gun AG2: turns windmill on VTOL up: pushes piston forward (if AG1 on)VTOL up/down: moves windmill (if AG2 on)Trim up: Releases piston/shoots spring gunRoll R: lifts ball into spring gun chamber Roll L: pushes corner pistons forward (3 total)Throttle up: allows balls to move into windmillBrake: allows ball to move past hatch after windmill Instructions for shooting initial ball:1. AG1 on, VTOL up (loads spring)2. Roll R gently (lifts ball into chamber)3. Trim up (shoots ball)4. Adjust camera as necessary5. If ball gets stuck in corner, roll L gently to push it along trackInstructions for resetting spring gun:1. AG 1 + VTOL middle (moves piston back)2. AG1 + VTOL up (loads spring)Instructions for loading next ball into position:1. Reset spring gun (instructions above)2. AG1 off, VTOL middle, AG2 on3. VTOL slightly up (moves ball through windmill)4. Brake down all the way to allow ball to move past hatch 5. Throttle up, allow one ball to pass, then throttle off to keep only one ball ready for windmill 6. (Optional) When ball reaches corner, roll L to push forward 7. Once ball is near spring gun, roll R gently to lift it into position (make sure the spring gun is reset first!)