Auto Credit Based on Trijetz's 1 Ton Challenge! (CLOSED)
Entry for the "1 Ton Challenge" I present to you, the Bumble-Bee Parasite Fighter! A very small, lightweight, and compact little aircraft, fitted with two wing-guns, it meets every standard and more when it comes to parasite fighters! Controls: take off from water with TRIM, and very lightly pull back on the stick to get it in the air. Can land on water and ground, but it can't take off from ground. Be very gentle if you're landing on water, it may flip around if you land too hard. If you're landing on ground, same precautions to take when landing on water, but you dont have to worry about flipping over, due to the skids it has on either side of the aircraft. Have Fun!
Specifications
General Characteristics
- Predecessor 1 Ton Challenge! (CLOSED)
- Created On iOS
- Wingspan 12.6ft (3.8m)
- Length 16.0ft (4.9m)
- Height 3.7ft (1.1m)
- Empty Weight 1,659lbs (752kg)
- Loaded Weight 1,999lbs (907kg)
Performance
- Power/Weight Ratio 1.685
- Wing Loading 36.1lbs/ft2 (176.3kg/m2)
- Wing Area 55.4ft2 (5.1m2)
- Drag Points 525
Parts
- Number of Parts 30
- Control Surfaces 5
- Performance Cost 84
@Trijets thanks! I worked very hard on it even though it's only 30 parts, and obviously weighs only a ton.
@AWESOMENESS360 sorry. I forgot to do it yeserday, but i just downloaded it. It flies really well, and I really like this build.
@Trijets I'd like to hear some feedback!
@Trijets did you try this out yet? I'd like to hear some feedback.
@Trijets thanks! Was a lot more difficult than I initially expected, hope you like it!
I will check it out tomorrow. Looks good!!!