Profile image

WELLINGTON

3,096 WWIIPlaneBuilder  9.5 years ago
29 downloads
No Tags
Auto Credit Based on Geebers's Wellington That KINDA Works

Credit to the original designer, i just made it fly a bit better, although it does seem to pull to the left s bit for me... INSTRUCTIONS:100% throttle to take off, press 1 after take off to jettison gear (might put retractable gear on for the designer next) then gradually throttle back, to stay below 300MP/H. The wellington was a successful bomber, with a "cross hatch" design, allowing bullets to go through one side and out the other, while causing no structural damage to the aircraft's fuesalage... But the wings are subject to damage. This bomber has front, back and side mounted turrets for defence. The camoflage is fictional. As i cant recreate squigly lines on the game, but has close resembalence in terms of colour.

General Characteristics

  • Predecessor Wellington That KINDA Works
  • Created On iOS
  • Wingspan 55.5ft (16.9m)
  • Length 42.8ft (13.0m)
  • Height 19.6ft (6.0m)
  • Empty Weight 10,802lbs (4,900kg)
  • Loaded Weight 14,997lbs (6,802kg)

Performance

  • Power/Weight Ratio 1.723
  • Wing Loading 35.8lbs/ft2 (175.0kg/m2)
  • Wing Area 418.5ft2 (38.9m2)
  • Drag Points 10914

Parts

  • Number of Parts 287
  • Control Surfaces 5
  • Performance Cost 595
  • Log in to leave a comment
  • Profile image
    4,227 Geebers
    Yea I tried with that but couldn't get the thrust where I wanted it with the mass being at a good spot too.
    9.5 years ago
  • Profile image
    @Geebers I made the CoM lower and further forward than centre of thrust... Also made it in line of centre of lift (doesn't matter if you dont understand what they are). To see these settings go into the pause button while building And press on CoM/CoL/CoT
    9.5 years ago
  • Profile image
    4,227 Geebers
    Thanks man! What did you do to fix it?
    9.5 years ago