PAC P1 Floats Kit
PAC's official float plane kit for the P1 Eagle model.
These floats enable you to fly off the water with your P1!
NOTE: These floats will only work on the P1B and P1C models. The P1A is too under-powered to take-off from the water and fly with the float kit installed. You must have either a B or C model, or have a P1A equipped with a non-factory engine like a Lycoming or Continental above 150 hp to use the floats.
Installation Instructions:
These floats require you to have the P1B or P1C.
1. Download float kit
2. remove temporary cockpit from the floats
3. grab the MAIN floats, and move them to the sub-assemblies
4. Name the main floats "PAC P1 Main Floats"
5. grab the Tail float, and move it to the sub-assemblies
6. Name the tail float "PAC P1 Tail Float"
7. Save "PAC P1 Float Kit" in your airplanes list
8. In your airplanes listing, find either your P1B or P1C which ever you have
9. Click on it to open it
10. Go to sub-assemblies, and grab "PAC P1 Main Floats" and PAC P1 Tail Float"
11. Remove your P1B/C's wheels
12. You will see 1 small cube-block on each main float. Align the floats until the cubes hook with the main gear struts.
13. replace your tailwheel with the tail float.
14. Save your plane as "PAC P1_ Eagle -Floats" ; replace _ with B or C
All done! Now go give it a test flight!
By default AG-4 is set with raising or lowering the water rudders
Specifications
General Characteristics
- Created On Windows
- Wingspan 9.0ft (2.8m)
- Length 23.5ft (7.2m)
- Height 5.4ft (1.7m)
- Empty Weight 855lbs (387kg)
- Loaded Weight 855lbs (387kg)
Performance
- Wing Loading 105.9lbs/ft2 (517.1kg/m2)
- Wing Area 8.1ft2 (0.8m2)
- Drag Points 1485
Parts
- Number of Parts 24
- Control Surfaces 0
- Performance Cost 138