---

134-CM-Lis Medium Tank.

A Cheap Medium Tank, With Good Crew Ergonomics And a Relatively Simple Design.

---

Protection

The Hull And Turret Are Rolled Homogeneous Steel Plates Welded Together, The Armor Is Good, But Not The Best, It Could Withstand Some Weaker AT Guns But Other Than That It Could Penetrated With Ease.

It Could Also Survive Some Penetrating Hits Aswell, As It Is The Result Of Its Survivable Crew Layout, The Turret Is Well Armoured.

Hull Front (Effective Thickness)

-Sloped Lower Plate (50+mm)
-Sloped Upper Lower Plate (110+mm)
-Angled Upper Plate (70+mm)
-Upper Plate On The Driver's Side (60+mm)

Hull Sides (Effective Thickness)

-Lower Plate (40+mm)
-Crew Compartment Overhang Plate (48+mm)
-Upper Plate (55+mm)

Hull Rear And Others (Effective Thickness)

-Lower Plate (36+mm)
-Upper Plate (35+mm)
-Roof Plate (15+mm)

Turret Front (Effective Thickness)

-Turret Face (67+mm)
-Gun Mantlet (60-95mm, 120+mm W/Overlap)
-Gun Mantlet Roof Plate (100+mm)

Turret Sides (Effective Thickness)

-Side Plate (45+mm)

Turret Rear And Others (Effective Thickness)

-Rear Plate (45+mm)
-Cupola Overlap (25+mm)
-Roof Plate (15+mm)

---

Arnaments

The Turret Of This Tank (Lis15) Is Capable Of Housing a Variety Of Arnaments.

Main Gun, Type6 76mm Multipurpose Cannon, T6M/2.75
-Pen At 100m, 128mm
-Reload Speed, 7.3 Seconds

(Type6 Multipurpose, Barrel Length 2.75 In Standard SP Fuselage Length Measuring)

Secondary Arnaments, 2 Coaxial Machineguns.

---

Controls

-Yaw For Hull Traverse
--Enable Foward And Reverse (AG1)
-Pitch For Foward And Reverse
--Enable Gun Traverse (AG2)
-Pitch And Roll For Gun Traverse

---

Mobility

This Vehicle Is Rather Mobile, Has a Good Power/Weight Ratio And Will Reach Its Top Speed (43Kph) In Around 20 Seconds.

Performance In Game

The Vehicles Top Speed Is 38Kph, The Acceleration Is a Little Too Much Than How Its Supposed To Perform IRL, It Also Feels Fast Even Though It's Just Going At 38Kph.

---

Hi There!

I Hope You Like This Design Of Mine! It Took a Little Longer Than Expected, Normally I Would Complete a Design Like This In a Day, Primarily Due To Delays!

But Now It's Done, And It Looks Very Pretty.