You made a plane with so much detail, gauges display and so much more, but need autopilot? now you can!

JUST ADD YOUR OWN AIRCRAFT HERE

main problem is, works with planes that fly with normal input,not Funky Tress
if theres FT input, its possible but a little tedious

HOW TO USE

• 1 save your airplane in Sub-assembly
• 2 make sure your aircraft didnt have custom variables, if have you have to move it too
• 3 add your aircraft to this autopilot buttons
• 4 change inputController on each control xml, so change
  elevator input to "Elevator" (without""),
  rudder input to "Rudder"
  engines input to "Engine"
  and lastly wing that control Roll to "APRwing"
  you can ignore Lwing1,Lwing2,Rwing1,Rwing2 as its just VTOL for flaps add if you want to
  and done!
  ps, if one side of elevator turning upside down, set it to invert mode

you can remove the fuselage,and the blue button that act as display. i just pressed the button to make the number visible

also you can resize,rearrange the buttons
or change buttons, just set input the same to the one you replace.

the speed is in Knots,IAS
Altitude is in Ft,Asl
i tested on my planes, MAPA AI planes if the plane fly ok with normal control, it work

dont forget upvote 👌
credit if you willing to, but not required