Four wheel drive
Front : double wishbone.
Add drive shaft
Restriction on extension side
Rear : solid axle.
Added anti-roll stabilizer
Specifications
Spotlights
- Paper 6.0 years ago
- LiamW 6.0 years ago
- senalPelpmiS 4.4 years ago
General Characteristics
- Successors 7 airplane(s) +37 bonus
- Created On iOS
- Wingspan 8.0ft (2.4m)
- Length 12.2ft (3.7m)
- Height 6.7ft (2.0m)
- Empty Weight 2,993lbs (1,357kg)
- Loaded Weight 3,126lbs (1,418kg)
Performance
- Wing Loading 89.4lbs/ft2 (436.3kg/m2)
- Wing Area 35.0ft2 (3.3m2)
- Drag Points 3306
Parts
- Number of Parts 259
- Control Surfaces 0
- Performance Cost 1,510
I have the little bugger advance v2 this is an improvement
@Kakofrutaka My English is not good either. But I really appreciate you. Thank you
@pilotWFD Thank you!
I am glad that more people make good suspension vehicles.
I am poor at English, but I will answer as much as possible if there is any technical doubt.
@Kakofrutaka I like your car and I like you. and Thank you for your reply. now, I'm your fans! I will download your car as soon as possible! Have more opportunities to communicate in the future(｡･ω･｡)ﾉ♡
@pilotWFD Thanks comment !
This car was made carefully for suspension geometry, aerodynamic balance, center of gravity balance.
Although the caster angle is set on the front wheel, I think that this method is a handy and effective technique.
that car was so fucking great
that was amazing. How did you do that?
sorry, I'm so excitedヽ(｡･ω･｡)ﾉ
@franticmatty this one also is one i highly recommend if your going to do a of that rally map
amazing!
@mraspy
Nice bruh nice
@Danillo
In order to make it compact and lightweight, parts modified with XML are necessary.
There are people uploading those parts.
Even without the help of MOD, you can make an accurate geometric suspension. That is very important.
Чтобы сделать его компактным и легким, необходимы части, модифицированные с помощью XML.
Есть люди, загружающие эти части.
Даже без помощи MOD вы можете сделать точную геометрическую подвеску. Это очень важно.
@Kakofrutaka для этого нужен какой-то мод?
@Danillo The procedure for making a suspension is
1. Understand the geometry of each type of suspension.
2. Make it once in large size.
3. Adjust the length and angle of the arm to achieve the desired performance.
4. Make it smaller.
Процедура изготовления подвески
1. Понять геометрию каждого типа подвески.
2. Сделайте это один раз в большом размере.
3. Отрегулируйте длину и угол наклона рычага для достижения желаемой производительности.
4. Сделайте это меньше.
Wow nice susption
как вы делаете такую подвеску???