Unlisted
No Tags
Could you make all the parts involved in the first picture 50% smaller? They are all connected by the block. If you must, you can remove the block, shrink it, the leave on the side for me to put back
Specifications
General Characteristics
- Successors 1 airplane(s)
- Created On Mac
- Wingspan 53.9ft (16.4m)
- Length 31.9ft (9.7m)
- Height 23.6ft (7.2m)
- Empty Weight 9,845lbs (4,465kg)
- Loaded Weight 11,706lbs (5,309kg)
Performance
- Horse Power/Weight Ratio 0.085
- Wing Loading 25.5lbs/ft2 (124.6kg/m2)
- Wing Area 458.8ft2 (42.6m2)
- Drag Points 10565
Parts
- Number of Parts 1633
- Control Surfaces 8
- Performance Cost 4,913
Comments
Upvotes
This post is unlisted and upvoting is disabled.
Oh I can’t do that @MrSilverWolf
With the ADI screens they have most of what the gauges do just as moving bars, but I've found if you multi select the black parts on the screen with multi edit it will actually show the screens that way and if you hit share aircraft in that state it keeps it like that so people can see the screens as if they were on
I sure hope so, I plan to post tomorrow at noon eastern time @MrSilverWolf
But you should definitely get a bunch from this one
Yeah it’s been like 4 months sense I made it and I’m still getting some@MrSilverWolf
@CRJ900Pilot I spotlighted that dash 8 I believe so some more upvotes should come out of that lol
Yeah I’m kinda stupid @MrSilverWolf
@CRJ900Pilot lol
@CRJ900Pilot the comment removing is only done via your own posts so I can't remove your comment on here only if you commented on my build
Wait nvm you can’t remove my comments XD @MrSilverWolf
Oh lol @MrSilverWolf
@CRJ900Pilot it didn't give me a notification that you removed that comment, interesting lol
I need one 1 more for 100 on my Dash8 @MrSilverWolf
Sure I’ll try with you, can you try with me on this comment? @MrSilverWolf
@CRJ900Pilot ah more upvotes, yeah I tend to try getting the most upvotes I can out of my posts lol
I mean I could remove gauges and corrugations but that is my clickbait and more upvotes. Oh did I say that out loud? XD @MrSilverWolf
@CRJ900Pilot the part count dose seem a bit high any way to reduce it a bit? But that's all I can think of other than a bit high part count it's great I didn't actually have a problem with the part count when you last linked it to me, it was pretty good, I like it!
Any other suggestions? @MrSilverWolf
@CRJ900Pilot no problem!
So I'll do that then
Thanks @MrSilverWolf
@CRJ900Pilot well I guess that works too
Just take the block, sub it, shrink it, then sub it again and then unlist it @MrSilverWolf
Then upload that as unlisted
@CRJ900Pilot ok well the multi edit doesn't like mass scaling unless it's the entire build nor using muilti edit so what I will do is pull it out of my sub assemblies scale it down 50% and fix a few things on it if needing fixes