Preparing for departure and takeoff

Before takeoff, it is necessary to adjust the Lights parameters, the action of which is not necessary, but it is desirable for greater realism.
You will need two white buttons on the panel, these are the buttons for starting and stopping the engines (Start / Stop engine 1, Start / Stop engine 2). Takeoff speed is approximately 410 km / h. After taking off on the LG toggle switch, this is the body assembly and if the Lights button was pressed, turn off the ignition by repeating this detection on this element.
Takeoff speed is approximately 410 km / h. After takeoff, press the LG toggle switch to retract the landing gear, and if the Lights button was pressed before, turn off the lights by pressing this button again.
After taking off from the ground up to 650 km / h, you need to maintain the same position of the steering wheel (toward yourself), after which you can either use the lever on the right to lower the angle of attack (trimming). 80% traction, 80% traction must be switched when reaching 700 km / h to save fuel

Level flight, tracking to the target, target acquisition by the MGM-9 missile

During the flight, we try to keep the speed at least 650 km / h. Adjust the angle of attack with the trimmer. After takeoff, you need to turn on the radar in the (Air-to-ground) mode, turning on the radar and switching search modes is done using the button
AA/AG to the left of the helm. Then use the NT button to select the target. the maximum capture range of the MGM-9 missile is 6.7 km, and the required number of missiles per destroyer is one. When acquiring a target and firing from the GAU-1, it is recommended to reduce the thrust to 20-40%. to launch a rocket, you must press the red Fox button.

Decoys, GAU-1 use, bombing

the orange LCM button is a decoy reset. the use of the GAU-1 gun. You can switch to the cannon using the NW button to the right of the steering wheel, shooting is done using the FG button. Bombing when selecting bombs with the NW button. When working in first person, the DB button is used to drop bombs.

Return to the airport and landing

Optionally, press the Light button to turn on the lights. When the strip has become visually long enough, you need to release the chassis using the LG button. When landing, use the altimeter under the main one, it shows the height to the ground, and not to sea level. Braking is done by pulling the left stick towards you, thereby releasing the brake flaps, there are also brake pedals in the legs. When the height to the runway is approximately 5 m, you can press the Catapult button and release the parachute, the plane will hit the ground almost immediately and all that remains is to apply the brakes.