No Tags
All i need is the landing gear to retract at least partialy into the wing. The tail wheel is not done either and i would like for it to be replaced. Only real requirement is i the landing gear has to retract using the gear action and not the vtol or trim sliders
Specifications
General Characteristics
- Successors 2 airplane(s)
- Created On iOS
- Wingspan 37.5ft (11.4m)
- Length 31.6ft (9.6m)
- Height 12.6ft (3.9m)
- Empty Weight 4,234lbs (1,920kg)
- Loaded Weight 6,086lbs (2,760kg)
Performance
- Horse Power/Weight Ratio 0.164
- Wing Loading 18.8lbs/ft2 (91.9kg/m2)
- Wing Area 323.3ft2 (30.0m2)
- Drag Points 1734
Parts
- Number of Parts 31
- Control Surfaces 6
- Performance Cost 253
@thanks for the suggestion anyways thats what im using for now lol
You should check out some of my finished projects if you have the time you might like em
@Airwolfpiskin I see, sorry. Thanks for correcting me! I haven't found anything to look better. Good luck!
@Harharhoman wing landibg gear doesnt close well because of dihedral. When the gear closes it slightly twists the wings. and eing gears look ugly specialy on this design. With the intake for the cooling system being a prominent part of the looks of the mustang its kinda anoying to have ugly wheels blocking that
Im not doing it for the suspension thats just there cause why not
And i want the gear to fold into the wing as much as posible so that doesnt happen
All gear assemblies have suspension, no need to do it how you're doing it, just use wing landing gear.