Ok so it’s not turbocharged, but I did get your attention. This Camaro was originally made by MoterKade, who is an awesome builder with awesome cars and even better chassis, it had a 0-60 of about 5 seconds and a top speed of 193 at Wright airport. He did an awesome job with detail and accuracy, But, I needed it to fly. I did a little bit of xml modding, it is still only wheel driven, and managed to get it a 0-60 of about .05 seconds and a top speed of 1600 at Wright airport. You may see a small jet under the hood (I had to remove the beautiful engine) but this is only for moving around slowly, the car had too much power to go less than 600mph. You can remove the jet and hit the same speed benchmarks. I also added parachutes (ag1), a functional front splitter, and an updated interior. There is two “speedometers” on the steering wheel and the dash because I couldn’t choose which one I liked better. There is a parachute lever on the dash. There is a “turbo” gauge on top of the dash that is controlled by pitch, there is also vtol nozzles on the hood to look like nitrous purging that are controlled by pitch. I did a few minor cosmetic stuff like lowering the hight of the hood, new exhaust setup, adjusted the steering wheel, I put a vtol nozzle on the flip headlights, and replaced the hot rod orange and black with blue and whiteThis was all done on mobile so don’t expect perfectionControlsGas- TrimTurn-Roll (be gentle)Parachute- AG1Nitrous Purge and psi Gauge- PitchHELPI’ve been trying to develop a hinge set up to simulate the 4 gears (ag1-ag4) but I can’t get one to work, if you have ideas let me know