Diamond D Jet (Regional Aircraft Challenge)
DIAMOND-D JET
A small civillian passenger jet with a capacity of 5 passengers. It is to be used by a few airlines, including Air Canada. Its aerodynamic design allows it to reach high speeds, and cruise at high altitudes. Though still in testing, a prototype has been made and sales confirmed.
FLIGHT CONTROLS
Normal Flight Controls
VTOL down - Flaps
VTOL up - Open passenger door
Landing Gear - Landing Gear
CREATOR'S NOTE
I encountered a lot of problems of space, so the cockpit is very cramped and basic. Working with the fuselage for this aircraft was also horrible and difficult because I wanted to include glass windows (Dont try, unless you have many hours straight spare), as well as a full passenger interior. The result it this: A realistic Diamond D jet, with a full passenger interior, glass windows - and the compromise is a cramped cockpit. I hope you like it.
Specifications
Spotlights
- CaptainBrayden 6 months ago
- WinsWings 1.6 years ago
- KmsGelvain 1.6 years ago
- Dissent3R 1.6 years ago
- ToeTips 1.6 years ago
General Characteristics
- Predecessor Regional Airliner CHALLENGE (CLOSED)
- Created On Windows
- Wingspan 48.1ft (14.7m)
- Length 47.1ft (14.3m)
- Height 15.8ft (4.8m)
- Empty Weight 11,543lbs (5,235kg)
- Loaded Weight 16,600lbs (7,529kg)
Performance
- Power/Weight Ratio 2.03
- Wing Loading 39.5lbs/ft2 (193.1kg/m2)
- Wing Area 419.8ft2 (39.0m2)
- Drag Points 3956
Parts
- Number of Parts 124
- Control Surfaces 7
- Performance Cost 814
great build !
Luxury
Wow! Thanks everyone, this is fast turning into my most upvoted build!
@windshifter1 I'm... not too sure about that
@RepublicOfCursedPlanes Wow, thanks! Ill try that for my next creation. A question, I noticed something, is it a glitch that if you have two glass fuselages, the less opaque one will override the other? It happened when I looked through a HUD behind custom cockpit glass.
@windshifter1 a tip for making good hollow windows without having to go through all this trouble:
1. take a hollow fuselage piece, and set thickness to 100%. (set the shape to “Curved” to get optimal results, and adjust the size of the window first)
2. Use the “Advanced Fill” (under the bit with “Vertical Fill”) to cut the edges off the fuselage piece.
3. After cutting, you should end up with a square piece that has a circular hole. Voila, a window has been made, and even better, you can connect these window pieces to each other, saving lots of work!
@windshifter1
Forgot to say, it is pretty sweet
@Toetips My Diamond D jet
@Nerdsta307 Thanks, im glad people are enjoying my work.
Bro I don't know how to thank you but thank you I was looking for an aircraft from the diamond manufacturer and I didn't think that on the website until I found this plane now yes I'm going to download this plane to Complete my list of downloads because I have more than 200 aircraft that I have downloaded and saved in my planes simple thanks the plane is very beautiful detailed congratulations
Thanks everyone for the upvotes! I didn't expect nearly so many, and in under 1 day!
im experincing this too with the windows, good job