1C. Flying Lorry 2
Whoops, Spin Problem, Corrected Here
May I Present the
Ferguson Flying Lorry
inspired by FishMiner's FM-K Berlinetta
There are several new things in this build for me. I spent way to long figuring out how to do a canvas cover for the bed and the new Fuel, RPM and MPH Gauge set is the cleanest one I've done. It has Green Turn Signals with the Red Low Fuel and Engine Off lights below them. The combination Map, Compass/GPS Gauge in the Center of the dash has a blinking indicator of your position as well as lights for islands that blink when you get close to them. It's surrounded by a red heading indicator that shows your direction of travel with Indications for all of the Islands, Kracken, and the Brown Pearl.
Canvas Bed Cover
The Canvas cover is moved with Trim up.
Side/Tail Gates
The Bed Sides can be lowered by using the Trim slider (0 to 50%) and/or AG2 and AG3 (0 or 50%). When both are used the Gates drop all the way down.
Controls
VTOL up to Hover and set "trim".
Throttle for Forward.
Brake to stop/Reverse.
Yaw to steer.
Pitch for up and Down.
Roll to Roll.
AG1=Lights.
AG2=Bed Sides. (0 or 50%)
AG3=Tail Gate. (0 or 50%)
AG4=Upper Window.
AG5=Lower Window.
AG6=
AG7=
AG8=Engines/Gyro.
Trim up=Canvas bed Cover.
Trim down=All Gates. (0 to 50%).
GearDown for the Doors.
Funky Trees
Hover Engine.
Turn Signals, Gauges, and GPS/Compass.
Enjoy and Comments are always welcome!
Specifications
Spotlights
- FishMiner 3.8 years ago
General Characteristics
- Predecessor FM-K Berlinetta
- Created On Windows
- Wingspan 9.8ft (3.0m)
- Length 24.3ft (7.4m)
- Height 10.2ft (3.1m)
- Empty Weight N/A
- Loaded Weight 632lbs (286kg)
Performance
- Power/Weight Ratio 540.331
- Wing Loading N/A
- Wing Area 0.0ft2 (0.0m2)
- Drag Points 5263
Parts
- Number of Parts 805
- Control Surfaces 0
- Performance Cost 3,267
@FishMiner
Found a Problem and corrected it. I hope that it doesn't mess up the spotlight as I created a redirect to the new build.
@FishMiner
Thanks for the Spotlight!
Thanks to
@TheNightmareCompany
@tsampoy
for your upvotes.
@UsualPoneer
Thanks for your comments and upvote.
@FishMiner
Thanks for your comments and upvote
Nice