Auto Credit Based on CoBros2's CONCEPT Propeller driven rotator
This is Cobros2's engine that is powered by a propellor engine. The major downside to this engine that it both creates very little torque and very little speed. This makes it not very useful in most situations, so I used gear reductions to increase the torque by about 3x. The red fuselage is the output that you would connect to whatever is being powered. I can continue adding torque via gear reductions to 9x, 27x, etc., but that would in turn lower the speed so I am not doing that unless it is needed. Anyways, thanks to CoBros2 for the discovery and I know that someone will have a use for this!
Specifications
Spotlights
- ThePrototype 6.3 years ago
- TigerEye35 6.2 years ago
General Characteristics
- Predecessor CONCEPT Propeller driven rotator
- Created On Mac
- Wingspan 11.5ft (3.5m)
- Length 25.9ft (7.9m)
- Height 13.6ft (4.2m)
- Empty Weight 6,027lbs (2,733kg)
- Loaded Weight 41,359lbs (18,760kg)
Performance
- Horse Power/Weight Ratio 0.024
- Wing Loading N/A
- Wing Area 0.0ft2 (0.0m2)
- Drag Points 13300
Parts
- Number of Parts 182
- Control Surfaces 0
- Performance Cost 477
Yes you can @Spacedoge12345plane
Could you use one of the piston engines and put a 3x torque gear on it to help the piston plane pull more weight
@IzzyIA That's sucks
I haven’t been spending much time on simpleplanes because I can’t really find anything new to build lol. Yeah so every once in a while I just think of something and upload it. @sexylips35
Are you there?
I hate it when that IzzyIA guy copies my gears @RYMA232Aeronautics
I was legit about to text u on insta to tell you somone copied your gears, then I realized u published dis.
Honestly, if I had the time and skill, I would use this in a car with no car engine
I might find something to make with this
I tried make a helicopter once using the prop to rotate a platform with blades, and nice job