It can be done with FT but it would be a little hard

well yes but i want to do non-funky trees lol
(and in that case, impossible with current stock non-FT stuff)
@edensk

Ive done it. check out my ejection seats on my t-38 its basically just the same code as lg stuff

@X4JB I did thanks to edensk and it works, if I try anything it just freezes the rotator.... but then again I wouldn't normally put a capital letter in the middle of a command either (ignitionDelay for example) so maybe I'm just not cut out for the computing/maths bit ;)

just use FT lol

@RamboJutter you're welcome, I'll look into it, there's a lot I could put in there

@edensk thanks, i will play with that, you definately need to do that useful commands list with a little desciprtion as to what does what, I find the other guides out there overly complex =)

@WolfSpark now if only i knew how to code funky trees... or even knew you could do this with them in the first place =) Even the codes for BIDMAS that snowflake quotes are diffeerent to when i went to school lol.

Some ones needs to make a sub assemble with all the different times .1-5 seconds or something

You can make it delay with FT ya know...
I do it with every function. Wether it be under an airspeed, etc etc.

@edensk Ok

@JeskoGoesVROOM you can already do it, read my first comment...

@tsampoy I'll think about it, not a bad idea

i want parachute delays so bad

@edensk you should make a forum listing your useful FT

floor(smooth(Activate1,1/x))
x is the delay, change Activate1 for whatever AG it is, put the input in the activation group field

FT works

Maybe its almost thesame sequence like this one? Click link

You can still use FT formulas used to delay the landing gears for example. I did that and my whole ejection sequence is activated only by AG7.