It has been 2 months, according to the site, that I haven’t posted anything, but that has changed. As you can see I’ve been working on a car, but not just any.... a flying car to be exact. It’s very difficult to operate but if you are able to read my instructions clearly you’ll be flying in no time... or driving... your choice. Here’s how it works: AG8 is car mode, when activated you use throttle to drive and roll to steer. In order to get into flying mode you have to do the following: Disable AG8, activate AG1 (Engine + flying details inside cockpit), activate AG2 + VTOL up, then deactivate it, activate AG3 + VTOL up till just underneath the top arrow. (Front wing placement for take-off) Deactivate it afterwards but keep VTOL fully up. Throttle up and wait for the car to take off by itself, in the meantime the car might drive a bit to the left because of a drag issue (SP physics...) so you can use jaw to drive straight. after take-off if you want to steer with the wheels out, the steering is inverted (i don’t know why but it only happens during that stage). When you gained a bit of altitude, activate and deactive AG3 & 4 and press the LG button (it’s for putting the front wings in the right position and retracting the wheels) For what I’ve experienced it’s probably best to do that part quickly so you can safely go back to steering the vehicle. Steering is the same as driving. Landing is more easy: VTOL in normall position, activate AG4 and press the LG button, slowly descent by flying at around a 5 degree angle at full speed and just touch down and brake. You can go back to car mode by activating AG2 & 3 when VTOL is in its normall position, deactivating AG1 and activating AG8 again. I hope the instructions are clear enough and enjoy I guess...