This was my first entry to the 10 Parts Challenge, however, I want YOU, yes, YOU to remodel this the best you can!
Rules
Must be a successor
Must be under 800 parts
Must have the same, or similar basic design, some differences can be made (AKA a Cockpit, or different wing design).
XML and Fine Tuner is allowed, but no other mods
Points
/10 on flyability
/10 on Funky Trees
/10 on design
/10 on similarity to old design
Max of 40 points possible.
The reward is the satisfaction of winning
Good luck!
Specifications
Spotlights
- RealMicroZackSP 2 months ago
- SpetzavodHeavyIndustries one month ago
General Characteristics
- Successors 9 airplane(s) +332 bonus
- Created On Android
- Wingspan 26.0ft (7.9m)
- Length 13.0ft (4.0m)
- Height 8.1ft (2.5m)
- Empty Weight 1,660lbs (753kg)
- Loaded Weight 2,665lbs (1,208kg)
Performance
- Power/Weight Ratio 1.264
- Wing Loading 21.8lbs/ft2 (106.4kg/m2)
- Wing Area 122.3ft2 (11.4m2)
- Drag Points 420
Parts
- Number of Parts 10
- Control Surfaces 5
- Performance Cost 49
@SpetzavodHeavyIndustries your country is russian and its abbreviation is SVSR which means "Союз Восточно-Социалистических Республик"
@Mosquitowithagun nvm, just realized the vertical stabilizer is set to semi-Symmetrical lol 😭☠️🙏
@SpetzavodHeavyIndustries check the connections, that has to do with it sometimes.
Mine is almost done, but why its always bank to the left nawh 😭 (I've tried to check the some suspicious mass, but nothing there ;-;)
Just make sure it's similar to this design
@JSTQ yes ig
A tailless delta wing, duckless wing, single vertical tail, single engine, belly inlet... according to these requirements, manufacture an aircraft, right?
I'm a bit busy rn but I'll see if I can get an entry in
@SPTNR ok.
I wanna join
But I'm scared because some plats gonna join
And my points are so large maybe newbies may lose
@keiyronelleavgeek566 ok. Thanks!
here’s my submission: https://www.simpleplanes.com/a/I9i2a9/Remodel-The-Plane-challenge-submission-24-parts