AG1: Deployment freight in the back. AG2: Gyroscope plane. AG3: Activation + Deployment drone (Throttle: Pitch) + Controll drone container lid (Trim up). AG4: Gyroscope drone. AG5-7 Deployment small packages drone. AG8: Activation flight controlls + Controll freight room door (VTOL up). Take-off from water (a bit tricky but do-able) and do whatever you want. If you want to drop the freight at the back, open the door (AG8 VTOL up), fly straight and activate AG1. close the door afterwards (duh). If you want to use the drone (it’s tricky) do the following: Activate AG2, Set the trim so the plane goes slowly up, Disable AG8. Select camera 1, Trim up, VTOL a little bit up, Pitch down and simultaniously activate AG3. (keep Trim up after release if you want to return). Fly around all you want and release the packages if you want, BUT stay within hearing range of the plane if you want to return the drone. At the time that you want to return, put the volume of the game up, that way you can locate where the plane is. After locating it catch up with it, or slow down towards it (it depends). Fly behind the plane and activate AG4 so you can do precision flying. Try to land in the drone container, it takes a few times but eventually you can make it. Afterwards put Trim back to normall to close the lid. Then you can switch to the plane again, so disable all AG’s except 8. Landing is around 25% Throttle and slow descent for a decent landing. I hope this isn’t too difficult to understand. Enjoy