@Erc90F4RU Would you be down for being my official aircraft tester? I would love a second opinion and thorough evaluation of my planes before upload and I think you could do a good job. You did find a mistake that 50 other people missed including myself.
There seems to be a minor issue in one of the vtol nozzles used for the afterburner still having it's swivel ability engaged. This WILL NOT affect aircraft performance and the solution is pinned below. Let me know if you have any questions. I may also post a fixed version tomorrow.
@Erc90F4RU Ah okey! Thank you much for bringing this toy attention. While building I must have forgotten to deactivate the vtol nozzle swivel. To fix this you are going to have to open the overload panel for the vtol nozzle. Then go to "Input Controller" and replace -90 and 90 with zeros. This should rectify the issue. Again big thanks for showing me this problem!
A possible solution...
https://www.simpleplanes.com/a/0RkZ9f/Midget-A380-stupid
I have a brief explanation on this post about what could be wrong. I gave it a shot to the best of my knowledge, so I hope it helps.
@XAircraftManufacturer I don't know what kind of magic you worked but HOLY MACKEREL the upvotes are flying in!
+1@BeastHunter Thanks!
+1@BeastHunter When in doubt CRASH IT OUT!
+1@Erc90F4RU I'm impressed! I'm amazed you could land it without wings!
@Erc90F4RU Where are the wings? Lol!
@Erc90F4RU Sweet! I look forward to working with you!
@Erc90F4RU Would you be down for being my official aircraft tester? I would love a second opinion and thorough evaluation of my planes before upload and I think you could do a good job. You did find a mistake that 50 other people missed including myself.
FYI
@Erc90F4RU Ah okey! Thank you much for bringing this toy attention. While building I must have forgotten to deactivate the vtol nozzle swivel. To fix this you are going to have to open the overload panel for the vtol nozzle. Then go to "Input Controller" and replace -90 and 90 with zeros. This should rectify the issue. Again big thanks for showing me this problem!
@Erc90F4RU Was this a result of toggling the vtol slider?
@Erc90F4RU What do you mean that 1 engine can roll? If you found a problem I would love to fix it!
SWEET
@MasterPlanes101 No problem, tried my best!
@ZSRAer0naut1cs No problem! Keep on building!
Sweet Job ZSRA! I think it is a super creative plane! I love the use of props and jets together. It's such a cool effect!
A possible solution...
https://www.simpleplanes.com/a/0RkZ9f/Midget-A380-stupid
I have a brief explanation on this post about what could be wrong. I gave it a shot to the best of my knowledge, so I hope it helps.
@ZSRAer0naut1cs Thank you so much! Your support is super appreciated! I dropped you a follow.