@RoastHam9146 Okay, so what should I look out for? Are there any correlation between the FT entries required for each feature? What should I do if I want to delete some of it?
@FalconDynamics Hello buddy, I'm making a new plane, I've done the appearance of it, but I don't know how to make its control system, I want to transplant the control system of your plane, I hope you can agree
@Graingy Yes, I scaled it down to a quarter of its original size to make it work on my computer, but even that still left a lot of people unable to run it
@PlaneFlightX I use AMD's 5600X to load this archive to spend 3 minutes and 09 seconds, and the loading speed is also related to your memory specifications and hard disk performance.
@wonkapilot In fact, if you have I5 9400f and GTX1660ti, 16GB ram can fully run this ship，If the memory capacity of your device is less than 16GB, it is more likely to crash during loading
@wonkapilot @NiMitZcvN68 I can provide my hardware information as a reference, CPU: R5 2600x (turn off hyper-threading function and overclock to 4.25Ghz), graphics card: RX580 2048SP, memory: 16GB (8G×2) DDR4 2666 frequency, storage: 512GNVMe SSD
@BogdanX Sometimes the application crashes, which is why I didn't use the sandbox mode screenshots as promotional covers, because no matter how many times I tried repeatedly, it would not load properly.
@BogdanX I had set power and buoyancy and steering components for her at the beginning of the construction. Now I can no longer enter the sandbox and sail. In order to take a screenshot of the sandbox, I can only do it in a Pause state.
@BogdanX Wait... You said someone used it to make a youtube video and tested Sailing, maximum speed, steering, stopping and firing, can you tell me the link to the video?
@JaeBeansS At first, it only had about 8000 parts. When I slowly added details, the parts gradually increased, and the frame rate of my device began to gradually decrease.
@JaeBeansS I divided it into multiple parts, including the front section of the hull, the rear section of the hull, the superstructure, and weapons. When I assembled these parts, I assembled them to add details.
@RussianAS Hmm... that’s true, my original plan was to make 1/2, and then zoom in to 1/1 before uploading, but found that the frame rate was too low during the construction process, so I had to shrink it again.
@justanotheranon This is a tedious and boring job, and it has been going on for three and a half months since April 1st. Since there is no computer, I can only make the hull section on the mobile phone.
@justanotheranon In fact, I am working on the manufacturing of Yamato. The current progress has reached 70%, totaling about 11000 parts. It is expected to be released in October this year.
This is a very good proposal, and this is what I always hoped. If the artillery is added to the "weapon", then the tank and the battleship will have good performance.
@RoastHam9146 Okay, so what should I look out for? Are there any correlation between the FT entries required for each feature? What should I do if I want to delete some of it?
+1@RoastHam9146 Hey buddy, can I port the control system on your plane?
+1@FalconDynamics Hello buddy, I'm making a new plane, I've done the appearance of it, but I don't know how to make its control system, I want to transplant the control system of your plane, I hope you can agree
+2@Graingy Yes, I scaled it down to a quarter of its original size to make it work on my computer, but even that still left a lot of people unable to run it
+3Do you have any special skills for building this ship? Or with the help of automated scripts?
+6@Sparky6004 I noticed that some problems in this archive need to improve, but it doesn't matter, I will re-register the correction archive.
+1@parkrangerjerry lol
@PlaneFlightX I use AMD's 5600X to load this archive to spend 3 minutes and 09 seconds, and the loading speed is also related to your memory specifications and hard disk performance.
+4@jamesPLANESii What is "performance cost", I use Google Translation I can't translate its correct meaning
+4https://www.simpleplanes.com/a/Y5ZLPg/YAMATO-1945
@CRATE52PART2 No problem, no need to care about authorization issues
+1@yokangy 12.46MB
+2@YamaYamatheMountain yep
+2@wonkapilot In fact, if you have I5 9400f and GTX1660ti, 16GB ram can fully run this ship，If the memory capacity of your device is less than 16GB, it is more likely to crash during loading
@wonkapilot @NiMitZcvN68 I can provide my hardware information as a reference, CPU: R5 2600x (turn off hyper-threading function and overclock to 4.25Ghz), graphics card: RX580 2048SP, memory: 16GB (8G×2) DDR4 2666 frequency, storage: 512GNVMe SSD
@Shippy456 Thank you:)
+1@BogdanX I recorded a short video of launching a sea trial, here is its link: https://youtu.be/p2p61hPtw2o
+1@MintLynx Thank you very much for your recognition
@AtomicCashew When I connect the various components, every time I change or edit a part, I need a buffer time of 10-15 seconds
@AtomicCashew Now it takes about 9 minutes to fully load her in this state
@aircraftarsenal123 On my device the loading time is 8 minutes and 50 seconds
@BusterShortWolf She has no special functions, you can use "VTOL" to control her main barrel, and "Trim" to control the turret steering
+1I don’t have a super computer that people say, just endure the heat of the device and the extremely low frame rate and insist on completing her
+2@BogdanX Sometimes the application crashes, which is why I didn't use the sandbox mode screenshots as promotional covers, because no matter how many times I tried repeatedly, it would not load properly.
@BogdanX I had set power and buoyancy and steering components for her at the beginning of the construction. Now I can no longer enter the sandbox and sail. In order to take a screenshot of the sandbox, I can only do it in a Pause state.
@BogdanX I haven't checked the specific time, but generally I can listen to 5-6 4 minutes of music from the beginning to the end of loading
@BogdanX Wait... You said someone used it to make a youtube video and tested Sailing, maximum speed, steering, stopping and firing, can you tell me the link to the video?
@WIZARD2017 I think it’s very worthwhile to spend all this time to complete her. She is a very beautiful warship itself, I like her very much
@JaeBeansS At first, it only had about 8000 parts. When I slowly added details, the parts gradually increased, and the frame rate of my device began to gradually decrease.
@JaeBeansS I divided it into multiple parts, including the front section of the hull, the rear section of the hull, the superstructure, and weapons. When I assembled these parts, I assembled them to add details.
+2@RussianAS Hmm... that’s true, my original plan was to make 1/2, and then zoom in to 1/1 before uploading, but found that the frame rate was too low during the construction process, so I had to shrink it again.
+1@EternalDarkness No problem, i don't mind
@PointlessWhyshouldi Haha...No, the processor used in my computer is AMD 2600X, the graphics card is RX580
+721k壬，冲
还有四天就2020了，19年十二月加急名单，上头批准了你优先往前排
+5@justanotheranon This is a tedious and boring job, and it has been going on for three and a half months since April 1st. Since there is no computer, I can only make the hull section on the mobile phone.
@justanotheranon In fact, I am working on the manufacturing of Yamato. The current progress has reached 70%, totaling about 11000 parts. It is expected to be released in October this year.
@Mumpsy This may be a bug, I have uploaded a new file. sorry
I also made a tank of this model 1.8 years ago.
Time flies so fast, I am very happy to see someone making another one today.
@Travelling 然而这个真的是用手机做的，只不过在电脑上发布而已，做的过程中全程都是在手机上
+1This is a very good proposal, and this is what I always hoped. If the artillery is added to the "weapon", then the tank and the battleship will have good performance.
@ThePrototype I am doing this work for entertainment only, it is not recommended to imitate in reality.
就是QBU88
有点像88霰
@EternalDarkness Interestingly, I am also using some of the designs that appear on your ship.
@EternalDarkness Because of the busy work, the new ship may take 1 to 2 months to build
@EternalDarkness Is a similar stitching, but the latter part will be slightly different
@EternalDarkness I am planning to build a new ship, it will use the new stitching method, there will be a new streamline.
This is really great
I saw some similarities to my design.