@Cai22267 i gave it a spin, i didn't remove the cockpit bit there might be a slight rolling to the left when flying, barely noticeable, but when you use your airbrake the plane rolls to the right, it's probably better to use an airbrake hidden in the fuselage instead of a wing inside the visual airbrake. other than that idk what would cause the rolling.
@Cai22267 have you looked into whether everything that is mirrored onto the other side of the plane has the same attachment points? if that's not it you can try looking into whether all the parts have similar drag , if that's uneven across the plane then that explains the turning, else if there are parts on one side of the plane but not the other, the centre of weight won't be in the middle of the plane, causing a rolling motion.
@TheFlightGuySP i can't figure it out, perhaps i asked the question wrong...
I'll give u some context: i"m trying to make my engine work in 3 scenarios: Throttle + 0.001 (to make it look like it's slowly spinning when in idle), (PID(ThrottleValue, TAS, 3.5, 0, 2.3) * !Activate8, which is autopilot's Throttle input and Brake & AltitudeAgl<10 & GS<20, to simulate full throttle when using Thrustreverser. I tried tinkering and whatnot but I aint no expert, i get stuck
KIJK! prachtding, als je een cockpit erin had geplaatst was het helemaal een plaatje! leuk gedaan met een camera voor refuelen. mooie details en goed design.
nu nog een wat krachtigere motor erin en het is de sport versie van de grand caravan! leuk om te zien dat je de remkracht van de wielen hebt kunnen instellen, anders is het zo hard
@ToeTips i like small aircraft, and i like the challenge of cramping as much stuff into a small space as possible. Also this makes it unusual, which i'm also formiliar with
for anyone stumbling along this wanting to add it to their design, I could not figure out how to copy paste it so I just turned my creation into a subassembly, downloaded the camera and put the camera in the cockpit of the subassembly. Also question @MisterT, want me to credit you once i use it?
@Cai22267 there were no flaps thus far i could figure out
@XEPOH ah, i c, tyvm
@Cai22267 i gave it a spin, i didn't remove the cockpit bit there might be a slight rolling to the left when flying, barely noticeable, but when you use your airbrake the plane rolls to the right, it's probably better to use an airbrake hidden in the fuselage instead of a wing inside the visual airbrake. other than that idk what would cause the rolling.
@Cai22267 can you send me the plane so i can take a look?
@Cai22267 have you looked into whether everything that is mirrored onto the other side of the plane has the same attachment points? if that's not it you can try looking into whether all the parts have similar drag , if that's uneven across the plane then that explains the turning, else if there are parts on one side of the plane but not the other, the centre of weight won't be in the middle of the plane, causing a rolling motion.
@TheFlightGuySP I tried getting it to work but i couldn't, thanks for trying to help me anyway.
@TheFlightGuySP i can't figure it out, perhaps i asked the question wrong...
I'll give u some context: i"m trying to make my engine work in 3 scenarios: Throttle + 0.001 (to make it look like it's slowly spinning when in idle), (PID(ThrottleValue, TAS, 3.5, 0, 2.3) * !Activate8, which is autopilot's Throttle input and Brake & AltitudeAgl<10 & GS<20, to simulate full throttle when using Thrustreverser. I tried tinkering and whatnot but I aint no expert, i get stuck
Hi guys, i got a question, i want to use the IF code for a project but i need 3 IF statements in one another, how would i type that?
@LunarEclipseSP Ty very much for the spotlight! :D
+1Thnx for the upvote! @Angelo135YouTube :D
@LunarEclipseSP I barely check the site nowadays but I got a big project going on atm :o
+1@Mousewithamachinegun122 Thnx for the upvote!
@HanakoSan ty so much for the spotlight & upvote! :D
+1@LunarEclipseSP :o ty! I hope it still works after 2 years... Thnx for the upvote, really appreciated! :D
+1pack a punch voor een vliegtuig, maarja dat krijg je met 4 motoren, goed gedaan!
KIJK! prachtding, als je een cockpit erin had geplaatst was het helemaal een plaatje! leuk gedaan met een camera voor refuelen. mooie details en goed design.
nu nog een wat krachtigere motor erin en het is de sport versie van de grand caravan! leuk om te zien dat je de remkracht van de wielen hebt kunnen instellen, anders is het zo hard
Als je het hebt over ketchup, is het altijd Heinz Ketchup!
WOW
goed bestuurbaar, leuk gemaakt. mooi detail met de ondervleugel!
leuk design, 1 ding is zeker, de kans op crashen is heel klein, zo bestuurbaar!
werkt inderdaad veel beter dan de vorige, gelukkig ook trim
ZO zeg wat een pitch down XD
ik crashte dit ding omdat het zo'n grote pitch heeft XD
de propeller raakt net nie de grond, daarnaast, echt rare ding dit
goofy ahh ding
vliegt goed, helaas geen flaps of glas om doorheen te kijken voor de cockpit maar alsnog leuk vliegtuig!
Thnx for the upvotes! @114333 & @NatsukiHoshino :D
thnx for the upvote! @Cosmicat :D
ty for the upvote! @Cosmicat :D
Thanks for the upvote! @CaptainIxcy :D
Thanks for the upvote! @RepublicOfCursedPlanes :D
@Kerbango too much work XD
this is a life safer, i thought i just finished the cockpit of my latest build but nope XD
+1Thanks for the upvote! @TomatoIsAFruit :D
@CatsinspaceYT well no since i tested it on one of my planes and that's when it happened, whilst flying
for some reason the top part is invisable behind the blue, only if i move it forwards by quite a bit i can see it again
I like the goofy landinggear and the fact that you need to get used to it, just like an actual plane
works good, i like the spinning fans, they are noisy tho
Thanks for the upvote! @Sjdhrjusjdidvfkfjfjfy :D
Thanks for the upvote! @Maxkiller7749862
Thanks for the upvote! @AviownCorp :D
+1Thanks for the upvote! @50CalChicken & @UniOnionLovers :D
Thank you very much for the upvote and spotlight! @Skyler101 :D
Thanks for the upvote! @ZerkkTheSimper :D
@ToeTips i like small aircraft, and i like the challenge of cramping as much stuff into a small space as possible. Also this makes it unusual, which i'm also formiliar with
+1Thanks you very much for the upvote and spotlight! @RepublicOfCursedPlanes and yes, how else are you suppost to sit in it XD
+1Thanks for the upvotes! @ToeTips & @Thunderthud :D
+1Just wow
+1for anyone stumbling along this wanting to add it to their design, I could not figure out how to copy paste it so I just turned my creation into a subassembly, downloaded the camera and put the camera in the cockpit of the subassembly. Also question @MisterT, want me to credit you once i use it?
+3